Differences

This shows you the differences between two versions of the page.

--- en:enablesoundonnuc [2016/08/19 15:57]
admin
+++ en:enablesoundonnuc [2021/08/25 10:29] (current)
@@ Line 1: / Line 1: @@
 ====== How to enable sound on the NUC ======
-You've just sent a video with sound on your zebrix nuc and there is no sound. This manual will guide you throught the steps to make the sound works correcly.
+You've just sent a video with sound on your zebrix nuc and there is no sound ? This manual will guide you throught the steps to make the sound works correcly.
 ===== Determine the output you need =====
@@ Line 18: / Line 18: @@
 ==== Open the Audio setting panel (or F3 keyboard shortcut) ====
-{{:soundsettings1.jpg|}}
+{{public_media:soundsettings1.jpg|}}
 ==== Select the sound card you want to use ====
-{{:soundsettings2.jpg|}}
+{{public_media:soundsettings2.jpg|}}
-{{:soundsettings3.jpg|}}
+{{public_media:soundsettings3.jpg|}}
 ==== (FOR DIGITAL STEREO ONLY) select the correct profile ====
@@ Line 32: / Line 32: @@
 In the audio setting go to the "Configuration" tab and select the profile you want to use.
-{{:soundsettings4.jpg|}}
+{{public_media:soundsettings4.jpg|}}
 You will note that unused output will appears as "unplugged" which will make the selection of the right profile easier.
-{{:soundsettings5.jpg|}}
+{{public_media:soundsettings5.jpg|}}
 ==== Test the volume ====
@@ Line 42: / Line 42: @@
 To define the right audio volume level you can set the volume in the "Output devices" tab
-{{::soundsettings6.jpg|}}
+{{public_media:soundsettings6.jpg|}}
 <WRAP center round important 60%>
@@ Line 52: / Line 52: @@
 The volume can be adjusted remotely with the zebrix hardware tool section
-{{::soundsettings7.jpg|}}
+{{public_media:soundsettings7.jpg|}}