Table of Contents
Screen already in use: factory reset recommended
- Press the settings button on the remote control (cogwheel icon)
- Go to admin
- Enter pin code (default: 000000)
- Reset to factory, the screen will go blank
New screen or first start-up after reset to factory settings
- Select Quickstart / Normal Configuration.
- Configuration of screen rotation language, input rotation activation, source: adapt if necessary (default settings can be kept as they are).
- Date and time configuration required!
- Done
DATE / TIME: It is very important to correctly configure at least the correct date, otherwise the first connection to zebrix in HTTPS will be impossible (certificate verification requires a correct date)
Configuring zebrix on the screen
- Start the screen with the power button on the remote control
- Press the parameters button on the remote control (cogwheel icon)
- In the EZ Setting category, go to SI Server Setting
- Select SI Server Setting.
- Set Fully Qualified domain name to ON.
- Enter the URL: https://screen.zebrix.net
- Application Launch mode: Local
- Application Type: ZIP
- Local application Upgrade: press Remote and confirm, this will launch the application download.
- Exit using the cross at top right
- Turn off the screen using the power button on the remote control
- Turn the screen back on using the same button and wait.
- A few seconds after restarting, a notification will be displayed confirming that the application has been downloaded/updated.
- A few seconds later, the application starts automatically and the zebrix activation page appears.
- After activation by the zebrix team, we recommend that you reboot the screen with the remote control one last time before using it.