Activate a Sony Android Screen in Signage

Check that the screen is properly connected to the internet

Check the firmware version:

Press the Help button on the remote, then go to System information

Note the following information:

The serial number

The screen ID

The screen model

Check the Software version, the package version must be at least PKG6.7532

Retrieve the MAC Address: Press the HELP button on the remote, then go to Network status and diagnostics, where you can find the MAC Address.

If the package version is lower than 6.7532

Press the “Help” button on the remote

Go to “System software update”

Click on “Software update” Let the screen perform the update, restart if necessary.

Register the screen: Choose the profile corresponding to the model

Go to Settings > System > About > Reset

Click on Factory Data Reset The screen will restart.

During the restart, the Sony screen will display a dropdown list to choose the language. Do not take any action and wait.

Go to the Provisioning section

Enter the code displayed on the screen The screen will provision on Sony’s RDM.

Exit Pro mode via the remote by pressing sequentially: i+ / mute / volume+ / home to enter “Pro settings”

The screen should display a banner indicating that it is in the “Pro settings in process” state.

Enable developer mode on the screen:

Go to Settings > System > About

Click on Android TV OS build (5 times)

Go to Settings > Developer options

Enable ADB debugging

Download the installation zip

Run the following commands according to your operating system

Run PowerShell as Administrator (required for ADB).

Enable script execution if necessary with the following command: Set-ExecutionPolicy Unrestricted -Scope Process

Run the script with the device’s IP: .\installzebrixsony.ps1 <ip_address>

(First, look up the IP in the screen's network settings)

Go to Settings > Pro settings

Click on Start Pro mode

Step 0: Before Provisioning the Screen